Life Fitness CSLAT Instrukcja Użytkownika

CLUB SERIES LAT PULLDOWNPart # 6941801Rev A.Revision:08/02/001ASSEMBLY INSTRUCTIONS

01234561/2 1/2 1/2 1/2 1/2 1/210ST`````FIGURE 7• Peel the backing off the WEIGHT STACK LABELS (12), line up sheet to the right of the selector openin

11FIGURE 8• Assemble the PLACARD LABEL (22) or the FOREIGN LANGUAGE PLACARD LABEL (23) to the FRONT SHROUD as shownin FIGURE 8.STEP 8:2322 721 4• At

11STEP 8:FIGURE 8(NOTE: If the PARTIAL SHROUD KIT is being used follow STEP 8. If the FULL SHROUD KIT is being used follow STEP 9.)28 3/8 X 3-1/2”27S

12STEP 9:FIGURE 9• SECURELY assemble the FRONT FULL SHROUD (31) and the REAR FULL SHROUD (32) to the TOWER (1) using ten 3/8 X3-1/2” BUTTON HEAD BOL

Clean:• Upholstery with mild soap and water.• Guide rods with a cotton cloth.• Hand grips with mild soap and water.• Frame damage can be repaired with

PARTS LISTKEYPART # DESCRIPTION QTYKEYPART #DESCRIPTION QTY1 69046xx ASSY TOWER 1 9 3102922 3/8 X 2-3/4” BOLT 81A 6920001 CABLE 1 10 3102905 3/8 X 3-3

STEP 1:FIGURE 1401234561/2 1/2 1/2 1/2 1/2 1/2• LOOSELY assemble the TOWER (1) to the BENCH FRAME (3) using four RH CAPS (27), two 3/8 X 3-3/4” BOLT

1A22N2A2M2D2E2L2K2C2I2G2J2F2H2B1A

5FIGURE 2STEP 2:• LOOSELY assemble the MAIN UPRIGHT (2) to the base of the BENCH FRAME (3) using four RH CAPS (27), two 3/8 X 3-3/4” BOLTS (10), four

601234561/2 1/2 1/2 1/2 1/2 1/2FIGURE 3STEP 3:• SECURELY assemble the KNEE SUPPORT (5) to the BENCH FRAME (3) using two BLACK RH CAPS (17), two RH CA

7STEP 4FIGURE 4• SECURELY assemble the SEAT PAD (18) to the BENCH FRAME (3) using two RH CAPS (27), two 3/8 X 2-3/4” BOLTS (9) andtwo 3/8” RH WASHERS

801234561/2 1/2 1/2 1/2 1/2 1/2STEP 5:FIGURE 5• Insert the two GUIDE RODS (26) (found in the SHROUD KIT) into the base of the TOWER (1) as shown in F

9• Screw the treaded end of the CABLE all way into the end of the shaft on the HEAD PLATE (8) and tighten jam nut securely. SeeFIGURE 6.STEP 6:FIGURE