M051-K50-B115 15 STACK MULTI-JUNGLEWITH HIGH & LOW PULLEYS (SM50)UNPACKING AND ASSEMBLY INSTRUCTIONS
SM50 Unpacking & Assembly Instructions107. Mount the seated row and lat bench to the frame. Using the bolts specified inFigure 12 and a 9/16” soc
SM50 Unpacking & Assembly Instructions11
SM50 Unpacking & Assembly Instructions12INSTALLING THE CABLESThe SM50 uses five cables. There are three different types of cable used on the SM50.
SM50 Unpacking & Assembly Instructions13 CROSSOVER CABLE ROUTINGOnce you’ve removed the pulleys as described previously, route the crossover cable
SM50 Unpacking & Assembly Instructions14LOW ROW CABLE ROUTINGRoute the low row cable as shown in Figure 17.Figure 17. Low row cable routing.
SM50 Unpacking & Assembly Instructions15Bolt the cable to the weight stacks as shown in Figure 18. Thread the 7/8” nut up on thecable bolt as show
SM50 Unpacking & Assembly Instructions16 TRICEP PUSHDOWN CABLE ROUTINGRoute the tricep pushdown cable as shown in Figure 20. Screw the cable into
SM50 Unpacking & Assembly Instructions17 HARDWARE0123456½½½½½½Hardware Figure 1. Assembly Parts.
SM50 Unpacking & Assembly Instructions18The parts shown in Hardware Figure 1 are used to assemble the SM50. They are:A. 7/16” x 6” hex head bolt
SM50 Unpacking & Assembly Instructions19The part shown in Hardware Figure 2 is the 9/16” cable jam nut that’s used to secure thecables to the weig
SM50 Unpacking & Assembly Instructions2The SM50 comes partially assembled. Follow the steps below to complete the assembly.WARNING: COMPONENTS OF
SM50 Unpacking & Assembly Instructions20Hardware Figure 5. Top assemblies.S. Teardrop pulleys (bolt on above lat and seated row bench) (2)T. 56” L
SM50 Unpacking & Assembly Instructions21Hardware Figure 6. Weight stack rubber bumpers.W. Weight stack rubber bumpers (inserted under weight stack
SM50 Unpacking & Assembly Instructions22PARTS LISTPart # ID Description QuantityMain components1234567891-stack cell4-stack cellLow row benchConne
SM50 Unpacking & Assembly Instructions230017-00101-14130017-00104-03680017-00103-0217Pulley hardware(installed)1-3/4” BoltCap washer3/8” Nyloc nut
SM50 Unpacking & Assembly Instructions3 UNPACKINGFollow the steps below when unpacking the components of the SM50.1. Cut off the shipping wrapper
SM50 Unpacking & Assembly Instructions4 ASSEMBLYFigure 2 shows an assembled SM50.Figure 2. SM50 main components (seats and cables removed for clar
SM50 Unpacking & Assembly Instructions5Figure 3. Set the weight stack cells.2. Bolt on the teardrop pulleys above the benches (see Figure 4) on t
SM50 Unpacking & Assembly Instructions6Figure 5. Configuration for 2-3/4” and 3” bolts.3. Bolt on the connecting beam (part 4 from Figure 2) usin
SM50 Unpacking & Assembly Instructions74. Mount the 56” lat top (part T from HARDWARE section) to the 4-stack cell using a5/8” socket and combina
SM50 Unpacking & Assembly Instructions8B. Unbolt the top plate and remove the guide rods using a 9/16” socket andcombination wrench (see Figure 1
SM50 Unpacking & Assembly Instructions9F. Bolt on the top plate. With the top plate on the guide rods, bolt on the top plateto the top of the cel
Nb