97Te, 95Te TreadmillsAssembly Instructions
Congratulations...and welcome to the world ofThe following Parts Identification Listing and the step by step assemblyprocedures have been assembled to
IMPORTANT SAFETY INSTRUCTIONS !¾ DO NOT position the rear of the treadmill within 6 feet ( 2 meters ) of the nearest obstruction. Thesides of the tre
TOOLS REQUIRED FOR ASSEMBLY... Phillips screwdriver, Torx wrench, 3/4” combination wrench, flat blade screwdriver (or 5/16” nutdriver)PARTS DESCRIP
IMPORTANT!DO NOT DISCARD THE SHIP KIT LOCATED ON TOP OF THE DECK AND BELT. ALL NECESSARY COMPONENTSNEEDED TO COMPLETE THE INSTALLATION ARE LOCATED IN
9. Position the right end of the ERGO FRONT CROSSBAR (#4) near thelarge access hole on the inside of the RIGHT UPRIGHT HANDLEBARBRACKET (L).Align the
15. Locate the LEFT ACCESSORY TRAY (#11). Carefully slide the tray into thetop of the LEFT UPRIGHT (#1) as shown until fully seated. Secure theaccess
PRE-OPERATION CHECKLIST⇒ Ensure that all fasteners are tight.⇒ Make sure the STRIDING BELT is properly tensioned and aligned according to the Operat
Komentarze do niniejszej Instrukcji